Télécharger Imprimer la page
Black & Decker HOME CAFE GT300 Guide De Mise En Route Rapide
Black & Decker HOME CAFE GT300 Guide De Mise En Route Rapide

Black & Decker HOME CAFE GT300 Guide De Mise En Route Rapide

Masquer les pouces Voir aussi pour HOME CAFE GT300:

Publicité

Liens rapides

55933Pub1000002353
6/1/05
4:51 PM
One-Cup Coffeemaker
PREPARING UNIT FOR FIRST USE
1. Remove the water reservoir from the back of the unit (A).
2. Remove reservoir lid and fill reservoir with water to the 7 oz., 9 oz.
& creamy line. Do not overfill.
3. Press the OPEN lid release lever to unlock the lid (B).
4. Insert a pod holder without using any coffee pods (C).
A
5. Close the lid by pressing down until you hear it snap in place (D).
6. Insert splash guard underneath the pod holder (E).
a. Align the splash guard tabs with the side openings on the unit.
b.Turn splash guard counterclockwise until securely in place.
7. With lid in place, slide reservoir down securely in place.
B
8. Place a 9-oz. or larger cup on the cup tray (F).
9. Plug in the unit.
10.Press the 7-oz. brew button. The blue indicator light blinks then
changes to steady blue. Once the priming cycle is finished the unit
beeps 3 times and the blue light goes out.
C
Note: During the priming cycle, the unit may be loud and create a larger
than normal amount of steam. This is normal.
Now your unit is ready for use!
BREWING A CUP OF COFFEE
1. Remove the water reservoir and fill with water according to the cup
size you are using (G).
D
2. Insert water reservoir back into the unit.
3. Unlock the lid by pressing the OPEN release lever to the open position.
4. Place appropriate pod holder in the unit (H).
5. Insert appropriate pod into the pod holder (J).
E
6. Close the lid.
7. Place cup on the cup tray. If using a tall cup or mug, remove the drip
tray (K).
Caution: Cup tray might get hot from previous brew; be sure it has cooled
completely before touching it.
F
8. Press the desired brew button. The brew button light blinks then
it remains on until the brewing cycle is finished.
Important: Make sure that your cup size matches your brew selection
(for example; use a 7-oz. cup for a 7-oz. brew selection), otherwise
Multiple
you might have an overflow (for example; do not use a 7-oz. cup for
brews
a 14-oz. brew selection).
9. When the brew button indicator light goes out, remove the filled
14 oz
cup from the cup tray.
10. To dispose of used pod, unlock lid and remove the pod.
7 oz
Important Tip
9 oz
The lid on your unit automatically stays locked during the brewing
cycle, if there is a power failure or if it stops unexpectedly.
G
To unlock the lid:
1. Press the STOP button.
2. Wait a few seconds then press the OPEN release lever on the lid. The
lid opens and the STOP indicator light goes out.
H
3. Close the lid and start a new brew cycle with an empty cup to avoid
coffee overflow.
Your Home Café™ coffeemaker has been specifically designed to use with
Folgers
and Millstone
®
damage your unit.
J
K
Get user manuals:
See SafeManuals.com
Page 1
Quick Start Guide
GT300, GT305, GT320
coffee pods. Using other brands of coffee pods can
®
Models
Cafetera de una taza
PASOS PRELIMINARES ANTES DEL PRIMER USO
1. Retire el tanque de agua de la parte trasera del aparato (A).
2. Retire la tapa del tanque y llene el tanque con agua hasta la línea
3. Presione la palanca (OPEN) para abrir la tapa (B).
A
4. Inserte un sostenedor de bolsitas, sin colocar una bolsita de café (C).
5. Cierre la tapa, presionando para abajo hasta quedar bien cerrada (D).
6. Inserte la guarda contra salpicaduras debajo del sostenedor de
B
7. Coloque la tapa sobre el tanque y deslice el mismo hasta encajar bien
8. Coloque una taza de 9 oz. o una más grande sobre la bandeja para
C
9. Enchufe el aparato.
10.Presione el botón de colado para 7 oz. La luz indicadora azul
Nota: Durante el primer ciclo de colado, el aparato puede producir ciertos
D
ruidos más fuertes al igual que mayor cantidad de vapor. Esto es normal.
¡La cafetera se encuentra lista para colar!
COLADO DE UNA TAZA DE CAFÉ
1. Retire el tanque de la cafetera y llene con agua según el tamaño
E
2. Instale el tanque nuevamente en el aparato.
3. Abra la tapa, presionando la palanca (OPEN) hasta abrirla
4. Coloque el sostenedor de bolsitas apropiado en el aparato (H).
5. Inserte la bolsita adecuada en el sostenedor de bolsitas (J).
F
6. Cierre la tapa.
Multiple
brews
14 oz
7 oz
9 oz
G
colado de 14 oz.
9. Cuando la luz indicadora del ciclo de colado se apague, retire la taza
10. Para desechar la bolsita de café usada, abra la tapa y retire la bolsita.
H
Consejos importantes
La tapa del aparato permanece cerrada automáticamente durante el ciclo
de colado, en caso de una falla eléctrica o si el aparato deja de funcionar
repentinamente.
J
Para quitar el seguro de la tapa:
1. Presione el botón de interrupción (STOP).
2. Espere unos segundos y presione la palanca (OPEN) de la tapa. La tapa
3. Cierre la tapa para dar inicio a otro ciclo de colado, utilizando una taza
La cafetera Home Café™ ha sido diseñada especialmente para funcionar
K
con las bolsitas de café Folgers
otras marcas puede dañar el aparato.
GT300, GT305, GT320
7 oz., 9 oz. y consistencia cremosa (Creamy). No exceda el nivel
de llenado.
bolsitas (E).
a. Haga coincidir las guías de la guarda con las aperturas laterales
del aparato.
b.Gire la guarda hacia la izquierda hasta encajar bien en su lugar.
en su lugar.
las tazas (F).
parpadea y luego pasa a luz fija. Al finalizar el ciclo, el aparato
produce tres (3) sonidos cortos y la luz azul se apaga.
de la taza que va a usar (G).
por completo.
7. Coloque la taza sobre la bandeja para las tazas. Si utiliza una taza
o un jarro alto, retire la bandeja de goteo (K).
Advertencia: La bandeja para las tazas podría estar caliente después
del ciclo de colado anterior; asegúrese de que se haya enfriado bien
antes de tocarla.
8. Presione el botón de colado deseado. La luz indicadora del botón
de colado parpadea y permanece encendida hasta finalizar el
ciclo de colado.
Importante: Asegúrese de que el tamaño de la taza coincida con el
ciclo de colado (por ejemplo; utilice una taza de 7 oz. para el ciclo
de colado de 7 oz. De lo contrario, el café se puede derramar. Para el
caso, uno no debe de utilizar una taza de 7 oz. para el ciclo de
de la bandeja para las tazas.
se abre y la luz indicadora STOP se apaga.
vacía para evitar que el café se derrame.
®
y Millstone
®
Instrucciones
de inicio rápido
Modelos
. El utilizar bolsitas de café de

Publicité

loading

Sommaire des Matières pour Black & Decker HOME CAFE GT300

  • Page 1 55933Pub1000002353 6/1/05 4:51 PM Page 1 Quick Start Guide Instrucciones de inicio rápido Models GT300, GT305, GT320 Modelos GT300, GT305, GT320 Cafetera de una taza One-Cup Coffeemaker PREPARING UNIT FOR FIRST USE PASOS PRELIMINARES ANTES DEL PRIMER USO 1. Remove the water reservoir from the back of the unit (A). 1.
  • Page 2 55933Pub1000002353 6/1/05 4:51 PM Page 2 Mise en route rapide is a trademark of The Black & Decker Corporation, Towson, Maryland, USA Marca registrada de The Black & Decker Corporation, Towson, Maryland, E.U. Marque de commerce déposée de la société The Black & Decker Corporation, Towson, Maryland, É.-U. Modèles GT300, GT305, GT320 HomeCafe™...

Ce manuel est également adapté pour:

Home cafe gt305Home cafe gt320