Publicité
Les langues disponibles
Les langues disponibles
SELECTING ADDITIONAL FUNCTIONS
An additional function can be added to the main washing program before pressing the Start button.
Select a program and then press the function button to add one or more desired additional function(s).
Defautlt temperature
and program
Cotton
Synthetic
Mix
Bed linen
Allergy
20°C
Fast 15 min.
Sterile 70°C
Wool
ECO 40-60
Rinse & spin
Spin & drain
Drum clean
i
• For the maximum spinning rate, program time, and other details of the ECO 40-60 program, and other
details of the ECO 40-60 program, please refer to the content on the Product Fiche.
• The table shows which cycle offers which options for adjustment.
• Adding an additional function will prolong the program time.
• Keep pressing the function button to make the desired selection of additional functions.
Manual interruption
To stop and cancel a washing program, press the START PAUSE button and hold it for 3 seconds. Select
the program SPIN & DRAIN and press the START PAUSE button. The appliance will run the program and at
the end of the program, the appliance pumps the water out of the drum. When the water is pumped out,
the door will be unlocked.
PAUSE button
The washing program can always be stopped by pressing the START PAUSE button. The washing program is
temporarily paused when the time remaining until program completion is flashing on the display unit.
If there is no water in the drum and water temperature is not too high, then the door will unlock after a certain
period of time, and it can be opened. To resume the washing program, first close the door and then press the
START PAUSE button.
ERRORS
In case of an error or fault, the program will be interrupted. An acoustic signal will warn about such
occurrence and the error will be flashing on the display [ E:XX ]. See the TROUBLESHOOTING TABLE for
more information.
Power supply failure
The washing program can always be stopped by pressing the START PAUSE button. The washing program is
temporarily paused when the time remaining until program completion is flashing on the display unit.
If there is no water in the drum and water temperature is not too high, then the door will unlock after a certain
period of time, and they can be opened. To resume the washing program, first close the door and then press
the START PAUSE button.
46
•
English
Default spinning
Delay
rate in rpm
800
�
800
�
800
�
1000
�
1000
�
1000
�
800
�
800
�
600
�
1400
�
1000
�
1000
�
--
�
Night
Soil
Pre
wash
level
wash
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
Extra
Speed
Steam
rinse
wash
clean
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
Publicité
