Safety Precautions - Inoksan PDG500N Manuel D'utilisation

9. LIGHTING INSTRUCTION
 Each gas knob controls 2 radiants aligned horizontally.
 Burning shall be performed downwards in order
starting with the upper radiant.
 For the first burning process (top burner), press button
''1' and turn counterclockwise from position ''0'' to
position and ignite by pressing on lighter no ''2''.
Keep pressing the button until the thermocupl gets
activated (approx. 15 sec. )
To rotate the skewer, plug the appliance plug "1" into a
socket and bring the key "2" with position "I-0-II" to the
postion "I" or "II" (Right/Left rotation).
10. SHUTDOWN INSTRUCTION
To shutdown the appliance, turn all knobs clockwise one
by one until they are at position 0 starting with the bottom
knob. Bring motor power switch to "0".
"Wait for 5 minutes before restarting the appliance
when you turn it off."
11.

SAFETY PRECAUTIONS

 When the surfaces of the robax glass and storage
system cools down, use a few drops of suitable cleaner
and wipe clean with a soft cloth or paper towel.
 Rinse thoroughly with water and dry with another
paper towel or soft cloth.
12. POWER INLET
 The appliance must be supplied with 110V AC 60Hz
mains voltage.
 The appliance must be grounded.
GROUNDING
WARNING : The appliance is equipped with a
three-prong (grounding) plug for your against
shock hazard and should be plugged directly
into a properly grounded three-prong receptacle. Do not
cut or remove the grounding prong from this plug .
The appliance, when installed, must be electrically
grounded in accordance with local codes, or in the absence
of local codes, with the National Electrical Code,
ANSI/NFPA 70, or the Canadian Electrical Code, CSA
C22.2
0
CLOSED
RIGHT BURNER FULL FLAME
RIGHT & LEFT BURNER FULL FLAME
RIGHT & LEFT BURNER HALF FLAME
12