ZANKER KHV3321N Notice D'utilisation page 24

What to do if...
Problem
You cannot activate or operate the
hob.
An acoustic signal sounds and the
hob deactivates.
An acoustic signal sounds when the
hob is deactivated.
The hob deactivates.
Residual heat indicator does not
come on.
You cannot activate the outer ring.
There is a dark area on the
multiple zone.
The sensor fields become hot.
There is no signal when you touch
the panel sensor fields.
comes on.
comes on.
24
Possible cause
The hob is not connected to an
electrical supply or it is connected
incorrectly.
The fuse is blown.
You touched 2 or more sensor fields
at the same time.
STOP+GO function operates.
There is water or fat stains on the
control panel.
You put something on one or more
sensor fields.
You put something on the sensor
field .
The zone is not hot because it op-
erated only for a short time.
It is normal that there is a dark area
on the multiple zone.
The cookware is too large or you
put it too near to the controls.
The signals are deactivated.
Automatic Switch Off operates.
The Child Safety Device or the Lock
function operates.
Remedy
Check if the hob is correctly connec-
ted to the electrical supply. Refer to
the connection diagram.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Activate the hob again and set the
heat setting in less than 10 sec-
onds.
Touch only one sensor field.
Refer to "Daily use" chapter.
Clean the control panel.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
Activate the inner ring first.
Put large cookware on the rear
zones if possible.
Activate the signals.
Refer to "Daily use" chapter.
Deactivate the hob and activate it
again.
Refer to "Daily use" chapter.