Removing And Installing The Metal Grease Filter; Cleaning The Metal Grease Filter - Gaggenau VL 414 111 Notice D'utilisation

Appliance part/ Recommended cleaning
surface
Stainless steel Use soapy water and dry with a soft cloth.
surfaces Only use a minimal amount of water when
cleaning so that no water enters the appli-
ance.
Soak dried-on food remains with a small
amount of soapy water; do not scour.
Remove severe stains caused by heat, yel-
lowing, or small rust spots on the damper
by cleaning it in the dishwasher with our
stainless-steel cleaning agent (Product No.
00311499).
Operating The soapy cloth must not be too wet. Dry
controls with a soft cloth.
Removing and installing the metal
grease filter
Removing the metal grease filter
1 Put the damper into mid-position and pull upwards
to remove. The damper will snap out of the holder.
Note: Be careful, the damper may scratch you when
removing and storing! Lift the damper straight up
and out and do not bend it.
2 Pull the metal grease filter up and out of the
appliance. Take out the positioning plate (if
installed).
3 Clean the metal grease filter and positioning plate.
4 Clean the interior of the downdraft ventilation.
Installing the metal grease filter
1 Insert the positioning plate (only by the side air
outlet, it must face the right way).
2 Insert the grease filter.
3 Press the damper down into mid-position until it
snaps into the holder on both sides with an audible
"click."
"
Note: The symbol
front.

Cleaning the metal grease filter

9
WARNING
Risk of fire
Grease deposits in the grease filter can ignite.
Clean the grease filter at least every two months.
Never operate the appliance without the grease
filter.
Notes
‒ Do not use any aggressive, acidic or alkaline
cleaning agents.
‒ When cleaning the metal grease filters, also clean
the metal grease filter holder in the appliance with a
moist cloth.
‒ You can clean the metal grease filters in a
dishwasher or by hand.
on the damper must be at the
13