Publicité
Les langues disponibles
Les langues disponibles
Installation
3
WashBar Installation
WashBar comes pre-assembled,
with the exception of the aerator.
When attaching flexible
PVC dryer tube, be
sure tube is touching
the WashBar nut when
complete.
A
Position bowl on the
floor, upright, as shown.
B
Assemble WashBar through basin
WashBar holes. Run cables and
tubes on left side only.
Soap Tube (Clear), 1/4" Water
Tube, LED Cable (Gray), Soap
Sensor Cable (Shorter Cable) and
Air/Water Cable (Longer Cable)
4
Aerator Installation
Carefully thread the aerator into
A
the WashBar casting using the red
service key provided. Ensure no
leaks after installation.
Bradley • 215-1843 Rev. E; ECN 18-08-023
WashBar
Single station shown; 2 station similar.
Connect grounding wire spade
terminal end to grounding washer
E
tab. Do not attach grounding wire
plug adapter to wall outlet until later
in the installation procedure.
Grounding Washer,
.25 QC
D
Nut, WashBar,
C
Attach the 1/4" supply
F
tube to the 1/4" union
elbow.
Aerator
(0.35 gpm or
0.5 gpm)
Red Service Key
2/4/2019
LVQD2
Attach flexible PVC dryer
tube to shank using hose
clamp. Tighten to 30-35
ft. lbs using 5/16" socket.
1-3/8-18
Secure from underside
with (2) nuts and (1)
grounding washer (right
side only).
11
Publicité
