Publicité
Les langues disponibles
Les langues disponibles
2 Functions and features
The vibration sensor detects the vibration in the system (measured / evaluated
physical unit = vibration velocity)� This is converted into an analogue signal at the
current output� The switching output behaviour is determined using the two setting
rings�
3 Installation
► Mount only in a thick housing wall (e.g. transport thread).
► Ensure that the signal direction is correct�
► Ensure a safe vibration transmission and allow no elastic intermediate layers.
► Tighten the sensor with a tightening torque of 15 Nm.
4 Electrical connection
The unit must be connected by a qualified electrician. The national and
international regulations for the installation of electrical equipment must be
adhered to�
M12
4
1
5 Settings
RMS Set
Effective value of the switching threshold, defining the limit value of the vibration
velocity�
Delay Set
Time in seconds during which the limit value must be effectively above the swit-
ching threshold (RMS Set) to activate the switching output (normally closed pin 4).
10
3
2
2:
4...20 mA
4:
1
L +
4
2
3
L
Pin 1: L+
Pin 2: 4...20 mA
Pin 3: GND
Pin 4: digital output
(normally closed)
Publicité
