CBE PRM350 Instructions D'emploi page 15

9)
3
10)
2
1
6.3
11)
OPERATING INSTRUCTIONS AND INSTALLATION
- Connection to other equipment which can dama
ge its correct operation may result in warranty
void.
- T he PR M350 r egulator is not suitable for the
charging of nickel/cadmium batteries, other kinds
of rechargeable or non rechargeable batteries not
outlined in this manual.
- The regulator is not suitable for external use.
- Install the regulator in an appropriate dry and
ventilated housing; make sure there is a minimum
distance of 200 mm from the front and
the sides of the device
surfaces.
- Do not cover the air intakes on the lid.
- Fasten the equipment with the screws on a flat
surface using the 4 holes on the base.
- Solar System cables should be placed far away
from the cables for Radio/TV/SAT antenna . s
Pic. 1 - DIMENSIONS (mm):
48
CONNECTION BATTERY TEMPERATURE SENSOR (optional)
Temperature sensor (mod. "C
it cannot be affected by other heat sources
When connected, the charging voltage
measured by the sensor.
CHARGE LINE SELECTOR.
BATTERY/ PHOTOVOLTAIC MODULES CONNECTION
Male faston type 6.3 for connection of the battery and the photovoltaic modules.
20 mm from
to the surrounding
140
150
TCB" L=3m) to be placed close to the battery
.
is adapted according to the temperature
- - The device produces heat during
operation. Make sure that the installation of other
equipment near the instrument does not hamper
the correct air flow and prevent the necessary
instrument cooling.
- Battery connection: use cables with adequate
section. Recommended sections:
- 6 mm (cable under 5m long) ²
- 10 mm (cable over 5m long) ²
- Protect the cable from any possible damage.
- Protect the 12V battery line using a suitable fuse
to be placed close to the battery.
- Lead-acid batteries shall be positioned in a well
ventilated place.
- Co nnect only 12V
batteries (capacity >40Ah).
- Only connect specific lithium batteries for the
sector.
, where
its
s
(6 cells) rechargeable lead
EN
normal
RV
15