Télécharger Imprimer la page

Blue Clean 610 Guide D'assemblage page 9

Psi 610

Publicité

Les langues disponibles

Les langues disponibles

OPERATING INSTRUCTIONS
H
D
D
Detergent Intake
Put the detergent tube (H) into the detergent bottle
and adjust the nozzle to the correct setting by
pulling the lance head out (- position). To restore
the standard pressure setting pull the lance back
(+ position).
Adjusting the working pressure
• The regulator is used to adjust the working
pressure. Turn clockwise for higher pressure, turn
counterclockwise for lower pressure.
96646_IM_610_1350PSI_ENG-FR-SP_A5.indd 9
96646_IM_610_1350PSI_ENG-FR-SP_A5.indd 9
C
D
D
Operation Tips
• Note: Test the GFCI before each use:
1. Plug GFCI into power outlet. Indicator should
turn green to show that cord has power.
2. Press test button, green indicator should
turn off to verify that GFCI cut off power to
the cord.
3. Press reset button – green indicator should
turn on to show that cord has power again.
4. When GFCI is working properly, green
indicator will turn on when power is applied.
If green indicator turns off, it has detected
electric leakage and the GFCI cut off power
to the appliance.
• If you hear the motor run intermittently when
the trigger is not being squeezed, that is
normal. The pump is priming itself so it is ready
to operate when the trigger is squeezed. Turn
off the power washer if not being used after five
minutes.
• The o-rings on the bayonet end of the nozzle
should be cleaned regularly and lubricated with
non-water soluble grease such as petroleum
jelly.
• Keep the nozzle cleaning wire for use in
unclogging the nozzle. If you lose the cleaning
wire, a straightened paper clip also works.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs
because the impact force of the water pressure
exceeds the durability of the surface. Bare wood
can be penetrated; paint can be peeled off, etc.
You can vary the force of your power washer by
controlling:
1. The angle of the surface being cleaned.
2. The distance of the nozzle from the surface
being cleaned.
NEVER use a narrow high pressure stream of
water on soft surfaces susceptible to damage.
9
2023/2/17 上午10:45
2023/2/17 上午10:45

Publicité

loading