Blue Clean 610 Guide D'assemblage page 12

TROUBLESHOOTING
If you have any questions regarding the product, please call customer service at 1-866-235-5112.
PROBLEM
Unit will not turn on. 1. The GFCI module on the end of the power cord must be plugged directly into an
The high pressure
(HP) hose will
not connect/stay
connected to the
spray gun. Is this a
spray gun problem?
The unit is running
but there is no water
flow.
Why is water leaking
where the high
pressure hose
connects to the
spray gun?
I can't remove the
lance from the spray
gun. What should
I do?
12
96646_IM_610_1350PSI_ENG-FR-SP_A5.indd 12 96646_IM_610_1350PSI_ENG-FR-SP_A5.indd 12
CORRECTIVE ACTION
outlet.
2. Do not use an extension cord.
3. With the GFCI Connected make sure the power switch is turned on.
Note: When power switch is turned on, the power washer will turn on by itself for
1-2 seconds and shut off. This is normal.
1. In most cases, the spray gun is not the problem. The problem is the rubber sleeve
covering the fitting at the end of the high pressure hose. It has likely slipped up
toward the metal tip. To fix: wiggle, twist and/or pull the rubber sleeve down until
the entire tip is visible plus an 1/8 in. of the metal fitting below the tip. Now try
to insert the hose tip into the spray gun. It should "click" into place and will not
come out until the hose is released by pushing in the lever on the underside of
the gun. You may cut away the end of the sleeve with a sharp knife if unable to
move the sleeve down. Be careful not to cut or puncture the hose.
2. Do not push in the release button when connecting the high pressure hose.
1. Power should NOT be turned on until water comes through the spray gun. Doing
so will damage the motor.
2. Check the water source.
3. Eject the nozzle from the lance to determine if clog is coming from the nozzle (If
nozzle is clogged, see nozzle cleaning instructions under "Cleaning nozzles").
4. Take off the lance and just spray out of the spray gun. This will indicate if the
problem is with the lance.
5. Check Garden Hose Adapter for loose connection and the filter for debris.
1. Make sure there is an o-ring at the end of the metal tip of the high pressure
hose. If no o-ring is present, the connection between the hose and spray gun
will leak. Additional O-Ring Kits are available online at www.arblueclean.com or
call Customer Service at 1-866-235-5112 to place an order.
1. All lances and the detergent bottles are attached and removed from the
extension lance in the same manner. Insert the quick-release end of the
lance/detergent bottle into the extension lance. Press the extension lance and
lance together (about a 1/8") and turn clockwise. The lance will lock in place.
Remove the lance by reversing this procedure. Press the extension lance and
lance together and turn counter clockwise. The lance will slide out.
2. Or, hold the extension lance and lance in an upright position with the
nozzle end on the floor. Push the whole assembly straight down to loosen
the connection, and then follow the removal process again. You may also
spray soapy water or a lubricant in the area where the lance connects to the
extension lance.
2023/2/17 上午10:45 2023/2/17 上午10:45