Publicité
Mechanical installation
4.4.6
Manual release assembly (optional)
NOTICE
The assembly of the manual release is done to the spring-applied brake which is already fitted
to the bearing shield
Abb. 12
Assembly of the manual release
12.1 Lever
12.4 Stud bolts
1. Insert four stud bolts (12.4) into the bore holes of the transport safety bolts which have been removed.
Tighten with a screwdriver.
2. Put the lever (12.1) onto the brake (14).
3. Place four cup springs (12.6) in alternate directions in each of the four sleeves (12.7). Finally, insert the
sleeves into the holes in the lever (12.1).
INTORQ | BA 14.0197 | 04/2016
24. The air gap of the brake is set to the rated air gap,
12.6 Cup springs
12.7 Sleeves
16.
12.8 Nuts
14 Brake
29
Publicité
