Publicité
Mechanical installation
4.4.5
Cover ring assembly
NOTICE
Brakes without flange require a groove in the bearing shield for the lip of the cover ring.
Abb. 11
Cover ring assembly
1
2
1. Pull the cable through the cover ring (13).
2. Push the cover ring (13) over the complete stator (1).
3. Press the lips of the cover ring (13) into the grove of the complete stator (1) and flange (6) or the bearing
shield.
NOTICE
Cover ring with condensation drain hole:
Fit the cover ring so that condensation can drain through the hole.
INTORQ | BA 14.0197 | 04/2016
DANGER
Brake may fail
If the manual release is not adjusted correctly the brake may fail.
Possible consequences:
❚ Severe injuries or material damage.
Protective measure:
❚ Ensure that the dimension "s" is observed.
Stator, complete
Armature plate
6
Flange
10 Cylinder head bolt
13 Cover ring
28
Publicité
