Télécharger Imprimer la page

Electrolux EHS 60041 P Notice D'utilisation page 12

Publicité

Les langues disponibles

Les langues disponibles

12 electrolux
What to do if ...
Problem
The cooking zones will not switch
on or are not functioning
Acoustic signal sounds when ap-
pliance is switched off
The residual heat indicator is not
displaying anything
Acoustic signal sounds and appli-
ance switches itself on and then
off again; after 5 seconds another
acoustic signal sounds
is lit
and number are displayed
If you are unable to remedy the problem
by following the above suggestions,
please contact your local Service Force
Centre.
1
Warning! Repairs to the appliance are
only to be carried out by qualified serv-
ice engineers. Considerable danger to
the user may result from improper re-
pairs.
3
If the appliance has been operated in-
correctly, the engineer's visit will be
chargeable, even during the warranty
period.
All manuals and user guides at all-guides.com
Possible cause
More than 10 seconds have
passed since the appliance was
switched on
The child safety device is switched
on
Several sensor fields were
touched at the same time
Automatic switch off has been trig-
gered
The control panel is wholly or part-
ly covered by objects.
The cooking zone was only on for
a short time and is therefore not
hot
The On/Off sensor field has been
covered up, e.g. by a cloth
Overheating protection for the
cooking zone has been triggered
Automatic switch off has been trig-
gered
Electronics fault
Remedy
Switch the appliance on again.
Deactivate the child safety device
(See the section "Child safety de-
vice")
Only touch one sensor field
Remove any objects (pan, cloths,
etc.) that are lying on the control
panel. Switch the appliance on
again
Remove objects.
If the cooking zone is supposed to
be hot, call the Customer Service
Department.
Do not place any objects on the
control panel
Switch off the cooking zone.
Switch the cooking zone on again
Switch off the cooking zone.
Switch the cooking zone on again
Disconnect the appliance from the
electrical supply for a few minutes
(Take the fuse out of the house's
wiring system)
If after switching on again,
displayed again, call the customer
service department
is

Publicité

loading