Publicité
Les langues disponibles
Les langues disponibles
WARNING: Incorrect combinations of grinding wheel, wheel guard and tool speed could result in injury. Correct
combinations are specified below:
Guard Part Number
AG20–106–3
LUBRICATION
Ingersoll–Rand No. 10
Ingersoll–Rand No. 50
Ingersoll–Rand No. 63
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For USA – No. C11–03–G00
After each two hours of operation, if an air line lubricator is
not used, inject 1/2 to 1 cc of Ingersoll–Rand No. 10 Oil into
the Air Inlet.
After each eight hours of operation, inject approximately
1 cc of Ingersoll–Rand No. 67 or Ingersoll–Rand No. 77
Grease into the Angle Grease Fitting. Excessive lubrication
will cause grease to work out around the Arbor.
CA200RG4 (Rear Exhaust)
CA120RG4 (Rear Exhaust)
ANGLE GRINDERS with 3/8"–24 SPINDLE THREAD
CA200RP63 (Rear Exhaust)
CA200RH63 (Rear Exhaust)
CA200RS4 (Rear Exhaust)
CA120RS4 (Rear Exhaust)
All manuals and user guides at all-guides.com
GRINDER SPECIFIC WARNINGS
Wheel Type
Wheel Diameter
27
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 67
Ingersoll–Rand No. 68
Ingersoll–Rand No. 77
HOW TO ORDER CYCLONE GRINDERS
ANGLE GRINDERS with 1/4" COLLET
Model
ANGLE SANDERS with 1/4"–20 SPINDLE THREAD
Maximum Wheel
in. (mm)
Thickness
in. (mm)
3 (76)
1/4 (6.4)
Do not mark any nonmetallic surface of this tool with
customer identification codes. Such action could affect tool
performance.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
3
Maximum Speed
rpm
26 250
FILTER
COMPRESSOR
(Dwg. TPD905–1)
Speed/rpm
20,000
12,000
20,000
20,000
20,000
12,000
Publicité
