Publicité
Les langues disponibles
Les langues disponibles
EN
SOLUTION
1 - Check the plug / socket.
2 - Disconnect and contact Steamer Technical Support.
1 - Add water by following the instructions on page 7.
2 - Clean the tank by following the instructions on page 11.
3 - Disconnect and contact Steamer Technical Support.
1 - Release the condensed water by pressing the steam trigger (3, page 6)
2 - Add water by following the instructions on page 7.
3 - Tighten the hose.
4 - Clean the tank according to the instructions on page 11.
1 - Direct the tip towards the bucket and unload.
2 - Wait for the rise of steam pressure.
3 - Turn off the power, allow the unit to cool down and drain the water from the tank.
Empty this water by operating the steam trigger over a bucket or sink.
1 - Make sure that the spring button is fully engaged in the hole in the tip.
1 - In case of discomfort, you can use a glove.
1 8
Publicité
