Publicité
Les langues disponibles
Les langues disponibles
USE OF STEAMER
1) Make sure the Steamer is unplugged and the switch in the OFF
position (12).
2) Unscrew the tank filler cap (5) by turning counterclockwise.
3) Using the measuring cup (10) and the funnel (11), fill the
Steamer with 1.8L of water. (This will produce about 35 minutes
of steam.)
4) Replace the filler cap by screwing it clockwise.
5) Attach the extension tubes to the steam handle (1) to obtain a
steam mop or attach the accessory adapter (23).
6) Connect the appliance and press the switch (12) to the ON
position.
7) Two lights come on. The indicator light (12) comes on to
indicate that the power is turned on. The orange steam light
(13) comes on to indicate a rise in steam pressure in the
appliance.
The appliance is ready for use when the
8)
steam indicator light (13) goes out and the
pressure reaches between 4 and 5bar
depending on the water level in the tank
(red zone of the Manometer (6 ).
9) During use, the orange steam indicator light (13) may turn
on again. This indicates that the steam pressure may not be
large enough. In this case, release the steam trigger (2) a few
moments. When the orange steam indicator light (13) goes off
again, you can resume using steam.
10) If the pressure drops below 2 bar, the steam flow may not be
sufficient depending on the accessory used. In this case, release
the steam trigger (2) and wait until the pressure gauge (6)
reaches the green zone again between 4 and 5 bar.
11) When activating the steam trigger (2), water may appear. This
is quite normal because at the beginning, the steam takes a
little time to arrive and the water condenses in the hose and the
extension tubes.
9
GREEN
ZONE
EN
Publicité
