Installation - Sony XAV-AX3005DB Mode D'emploi

Installation

Removing the bracket
Before installing the unit, remove the bracket 
from the unit.
1
Insert both release keys  until they click,
and pull down the bracket , then pull up
the unit to separate.


Face the hook inwards.
Mounting the unit in the dashboard
• Before installing, make sure the catches on both
sides of the bracket  are bent inwards 3.5 mm
( 5 / in).
32
• For Japanese cars, see "Mounting the unit in a
Japanese car" (page 29).
1
Position the bracket
dashboard, then bend the claws outward
for a tight fit.


inside the
Larger than
Catch
182 mm (7 1 /
Larger than
111 mm (4 3 / in)
8
2
Mount the unit onto the bracket

Notes
• If the catches are straight or bent outwards, the unit will
not be installed securely and may spring out.
• Make sure the 4 catches on the protection collar  are
properly engaged in the slots of the bracket .
Mounting the unit in a Japanese car
You may not be able to install this unit in some
Japanese cars. In such a case, consult your Sony
dealer.

Bracket
Parts supplied with
your car
When mounting this unit to the preinstalled
brackets of your car, use the supplied screws  in
the appropriate screw holes based on your car:
T for TOYOTA and N for NISSAN.
in)
4
Note
To prevent a malfunction, install only with the supplied
screws .

.

To the dashboard/center console
Bracket

29
GB