Publicité
Les langues disponibles
Les langues disponibles
4.1 - "Slider" Function
This allows you to turn the lamps On and Off and to adjust the bright-
ness dynamically. The capacitive strip acts like a slider:
Procedure
short touch on the slider
sliding your finger on the
slider
4.2 - LED (Fig. 5)
The LED on the lower part of the TTD0110 sends various signals in the
programming procedures and some general signals:
Flashes
Colour
Execution
at the end of a
6
green
transmitter memori-
sation procedure
when the dimmer is
2
green
powered
during any program-
2
red
ming procedure
it comes on when
on
the power supply
blue
fixed
unit /driver is acti-
vated
All manuals and user guides at all-guides.com
Description
absolute positioning command
progression of commands to adjust the
brightness dynamically: sending com-
mands regardless of where you place
your finger
Description
the memory is full:
the transmitter
cannot be memorised
its memory is empty
(= no transmitter
memorised)
an error was
committed
voltage to terminals
5 and 4
5
LED red / green
In this manual the programming procedures are explained with the use
of icons and their meanings are shown in the table below:
LED: behaviour during the programming procedures
Symbol
Description
ON
OFF
LONG flashing
SHORT flashing
FAST flashing
other symbols
Symbol
Description
OFF
DISCONNECT POWER
LED blue
KEY
English – 5
Publicité
