Nice TTD0110 Instructions Et Avertissements Pour L'installation Et L'utilisation page 4

ENGLISH
Instructions translated from Italian
CONTENTS
1 GENERAL WARNINGS
2 PRODUCT DESCRIPTION AND INTENDED USE
3 ELECTRICAL CONNECTIONS
4 PROGRAMMING
4.1 "Slider" Function
4.2 LED
4.3 Transmitter recognition procedure
4.3.1 Using the "First Transmitter" (Empty Memory)
4.3.2 Using "Further Transmitters" Mode 1
4.3.3 Using "Further Transmitters" Mode 2
4.3.4 Using the "External Button" Mode 2
4.4 Memory deletion
4.4.1 Using the "Memorised Transmitter"
4.4.2 Using the "External Button"
4.5 Programming the brightness levels
4.5.1 Using the "Memorised Transmitter"
4.5.2 Using the "External Button"
4.6 Programming the locking and unlocking of the memory
4.6.1 Using the "Memorised Transmitter"
4.6.2 Using the "External Button"
5 Replacing a fuse
6 TECHNICAL SPECIFICATIONS
7 DISPOSAL OF THE PRODUCT
EC declaration of conformity
All manuals and user guides at all-guides.com
1 - GENERAL WARNINGS
• WARNING: Important safety instructions. Follow all instruc-
tions as improper installation may cause serious damage.
• ATTENTION: Important safety instructions. It is important for
you to comply with these instructions for your own and other
people's safety. Keep these instructions.
• Children must not play with the appliance.
• Do not allow children to play with the fixed control devices of the
product. Keep the remote controls away from children.
• Check the system frequently, especially check the wires for signs of
1
wear or damage. Do not use the device if it needs repair or adjust-
ment, because an installation failure can cause injury.
2
• Cleaning and maintenance that should be carried out by the user
2
must not be carried out by unsupervised children.
4
• ATTENTION: in order to avoid any danger due to inadvertent reset-
5
ting of the thermal cut-off device, this appliance must not be powered
5
through an external switching device, such as a timer, or connected
6
to a supply that is regularly powered or switched off by the circuit.
6
• Before starting installation, check the "Product specifications" (in this
manual). If it is not suitable, DO NOT continue with the installation.
7
• The packing materials of the product must be disposed of in compli-
7
ance with local regulations.
8
• Before proceeding with the installation of the product, check that all
9
the materials are in good working order and suited to the intended
9
applications.
9
• The manufacturer assumes no liability for damage to property, items
10
or persons resulting from non-compliance with the assembly instruc-
tions. In such cases the warranty for material defects is excluded.
10
• Before working on the system (maintenance, cleaning), always dis-
11
connect the product from the mains power supply.
11
• Provide a disconnection device (not supplied) in the plant's power sup-
11
ply grid, with a contact opening distance that permits complete discon-
12
nection under the conditions dictated by overvoltage category III.
13
• Handle the product with care during installation, taking care to avoid
13
crushing, denting or dropping it, or allowing contact with liquids of
13 any kind. Keep the product away from sources of heat and naked
flames. Failure to observe the above can damage the product, and
14
English – 1