HAMPTON BAY EST-540T-40R Guide D'utilisation Et D'entretien page 9

Operation
Read All Instructions Before Use
Check that the heater outlet grill is not covered or obstructed in anyway, and make sure the power to the unit is switched on.
NOTE: When the heat function is used for the first time, a slight odor may be present. This is normal and should not occur again unless the
heater is not used for an extended period of time.
1
Using the Control Panel
□ The control panel is located behind the door of the stove.
□ Main Power Switch: The Power
supplies power to all of the functions of the
stove. This switch must be in the ON position
for any functions to work.
□ Flame Effect: Toggle the Power Switch ON.
The Power indicator light will glow. The flame
effect will be visible through the front glass.
□ Temperature Knob: Toggle the Temperature
Switch ON, the Temperature control knob regulates the temperature level of the room. The further the knob is rotated
clockwise, the higher the temperature setting. Turning the knob counter-clockwise will lower the temperature setting.
Use this function to help regulate the ambient temperature level.
□ Temperature Limiting control: This heater is equipped with a Temperature Limiting Control. Should the heater reach
an unsafe temperature, the heater will automatically turn off. To reset: Unplug the power cord from the outlet. Wait 5
minutes. With the Power switch in the OFF position, plug the power cord back into the outlet.
2
Using the Remote Control
1. Main Power Button: This button supplies power to all the functions of the electric fireplace. The main power button
must be in the ON position, either from the remote or the controls on the electric fireplace for the functions to work.
Battery Replacement Procedure: (Size CR2025)
Battery replacement instruction
CR2025
RELEASE
Switch
OPEN
PUSH
The plastic tab inside the battery
compartment MUST be removed
before the remote control will operate.
(Pull tab)
9
1
Please contact 855-HD-HAMPTON for further assistance.
HAMPTONBAY.COM