Publicité
Les langues disponibles
Les langues disponibles
Maintenance
GLASS INFORMATION
□ Under no circumstances should this product be operated with broken glass.
□ Do not strike or slam the glass.
□ Do not use abrasive cleaners to clean the glass.
□ This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be done by a qualified service person.
LIGHT bULb INSPEcTION AND REPLAcEMENT
The flame effect is created by two 40-Watt light bulbs with an E-12 (small) socket base. Use only this type of light bulb. If the flame effect
does not work, the bulbs may have come loose or been damaged during shipping.
CAUTION
Light bulbs become very hot during use. Allow at least 10 minutes for the bulbs to cool before touching.
To inspect or replace the bulbs, first unplug the power cord from the outlet. Locate the access panel on the back of the stove. Remove the
screws and the panel. Check the bulbs to be sure they are finger tight and in working order. Replace any damaged or faulty bulbs. Reattach
the access panel. Do not operate this heater without the access panel in place. Do not remove the back cover of this heater. There are no
serviceable parts inside.
WARNING
Do not exceed 40 watts per bulb. Use of higher rated bulbs may result in a fire, causing property damage or personal injury.
MOTOR MAINTENANcE
Always disconnect the appliance from the main power supply and allow it to cool before any servicing operation.
The motors used on the fan heater and flame blower are pre-lubricated for extended bearing life and require no further lubrication. However, peri-
odic cleaning/vacuuming of the appliance around the air intake and exhaust, as well as the fan heater is recommended. For heavy or continuous
use, periodic cleaning must be done more frequently. If the heater blows alternating cold and warm air, check the fan for free movement and for
debris restricting air flow. If the fan does not move freely, the unit must be turned off and the fan replaced immediately in order to prevent further
damage to the unit.
Care & Cleaning
Always turn the stove OFF and unplug the power cord from the outlet before cleaning. Use a vacuum or duster to remove dust and dirt
from the heater and vent areas. To maintain the finish, clean with a soft, slightly damp cloth and buff with a dry cloth. Never use abrasive
cleansers, liquid sprays, or any cleaner that could scratch the surface.
10
Publicité
