Pioneer VSX-819H-K Mode D'emploi page 51

Making recordings
Chapter 9:
Making recordings
Making an audio or a video
recording
You can make an audio or a video recording
from the built-in tuner, or from an audio or
video source connected to the receiver (such
as a CD player or TV).
Keep in mind you can't make a digital
recording from an analog source or vice-versa,
so make sure the components you are
recording to/from are hooked up in the same
way (see Connecting up on page 11 for more on
connections).
If you want to record a video source, you also
need to use the same type of connection for the
source as for the recorder. For example, you
can't record a component hooked up to
composite video jacks with a recorder hooked
up to the component video outputs (see
page 17 for more on video connections).
RECEIVER
INPUT SELECT
ZONE 2
RECEIVER RECEIVER
ON/OFF
BD BD TV TV
CD CD CD-R CD-R
VIDEO VIDEO MULTI IN
iPod USB iPod USB DIMMER
Note
1 • The receiver's volume, balance, tone (bass, treble, loudness), and surround effects have no effect on the recorded signal.
• Some digital sources are copy-protected, and can only be recorded in analog.
• Some video sources are copy-protected. These cannot be recorded.
All manuals and user guides at all-guides.com
SOURCE
TV CONTROL
INPUT
DVR DVR
CH
TUNER TUNER
AUX AUX
VOL
SIGNAL SEL SIGNAL SEL
BD MENU
1 Select the source you want to record.
Use the MULTI CONTROL buttons (or INPUT
SELECT).
2 Select the input signal (if necessary).
Press the RECEIVER button then press
SIGNAL SEL to select the input signal
corresponding to the source component (see
page 40 for more on this).
3 Prepare the source you want to record.
Tune to the radio station, load the CD, video,
DVD etc.
4 Prepare the recorder.
Insert a blank tape, MD, video etc. into the
recording device and set the recording levels.
Refer to the instructions that came with the
recorder if you are unsure how to do this. Most
video recorders set the audio recording level
automatically—check the component's
instruction manual if you're unsure.
5 Start recording, then start playback of
the source component.
1
09
51
En