Robstep X1 Manuel D'instructions page 59

All manuals and user guides at all-guides.com
4. Maintenance of Robstep X1
User needs to conduct routine maintenance
for Robstep X1. This chapter mainly
introduces some maintenance tips.
WARNING!
• Before conducting below operation,
ensure the power supply and the
charging cable are disconnected. When
power is on or the battery is under
charging, the following operation is
forbidden.
4.1 Maintenance
• Inspect regularly on screws of front and
rear tires to see if they are tightened.
• Check the outer tires tread to see if there
is any abrasion and crack. If the tires
are worn, please contact Robstep or its
appointed agents.
• Inspect regularly on screws of Robstep
X1 if they are tightened. If they are loose,
please tighten up.
• Before using, please check to confi rm the
folding button is buckled up.
• Check regularly to see if there is any
broken parts. For any replacement,
please contact Robstep or its appointed
agents.
WARNING!
• For safety, if the battery reaches to 600
cycles, please return for inspection.
4.2 Cleaning
• Please use neutral detergent on Robstep
X1, wipe with a cloth, and then clean
again with a dry cloth.
WARNING!
• Do not spray water or other liquid
on Robstep X1 as to protect internal
electrical components and circuits from
being damaged.
4.3 Handling
• Lift and put down Robstep X1 with
proper skills:
• Make sure Robstep X1 is not connected
with the charger and is in power off
status.
• Lift with two hands at the middle of
Robstep X1 for handing. Please do not
use the handlebar as the main force.
4.4 Storage
• Please store Robstep X1 indoors with
dry and suitable temperature. If it isn't
used for a period of time, please do not
connect it with power supply.
WARNING!
• User should not open internal circuit or
motor.
• Modifi cation voids warranty.
• User should store Robstep X1 with a fully
charged battery, if not using for a long
period of time. And the battery should be
charged every three months.
GB
59