Configuration Menu Of The Radiator Thermostat - HomeMatic IP Starter Set easy connect Notice De Montage Et D'emploi

holes marked using a 1.5 mm drill.
• Place the bracket of the electronic unit to the desired mounting
location and turn both screws (2.2 x 16 mm) into the screw holes
(see figure 8).
• Insert the electronic unit into the bracket.
• Place the back side of the magnet contact or the spacer to the
desired mounting location and turn both screws (2.2 x 13 mm)
into the screw holes (see figure 8).
• Place the magnet in the bracket and insert the back side into the
housing of the magnetic contact.
When using the spacer, you can simply attach the magnet
contact after installation to the spacer.
6 Configuration menu of the radiator
thermostat
When using the radiator thermostat without Homematic IP Access
Point, you can select the following modes via the configuration
menu after set-up directly on the device and adjust the settings to
your personal needs.
By pressing and holding the menu button (G) for at least 2 s, you
•
will be entering the configuration menu.
Select the desired icon via the plus and minus buttons (E and F)
•
by pressing the menu button briefly to change the settings of the
different menu items.
Press and hold down the menu button to get back to the previous
level. The menu automatically closes without applying changes if
there is no operation for more than 1 minute.

Configuration menu of the radiator thermostat

47