Publicité
Les langues disponibles
Les langues disponibles
Reverse osmosis water filtration system
The water pressure of the water supply system to a reverse osmosis water filtration
system must be between 241 kPa and 827 kPa.
The water pressure of the reverse osmosis water filtration system to the refrigerator's
cold water line must be at least 276 kPa. If the water pressure is below the specified:
• Check if the sediment filter in the reverse osmosis system is blocked. Replace the filter
if necessary.
• Refill the water tank in the reverse osmosis system with water.
• If your refrigerator has a water filter, it may further reduce the water pressure when
used in conjunction with a reverse osmosis system. Remove the water filter.
For more information or servicing, contact a licensed plumbing professional.
NOTE
WATER FILTER MUST BE INSTALLED.
• Make sure to install a water filter.
• Failing to install a water filter may allow fine foreign materials (sand, lime) in the water
to continuously enter the water supply line and possible cause defects in the water
supply system.
Ordering a new filter
To purchase a new water filter (part type: HAFEX/EXP), contact a local Samsung service
centre.
To mount the water filter into place
Untitled-8 35
1. Attach the lock clips (x2) to appropriate
positions under the sink, for instance.
Then, fix the lock clips firmly using
screws.
2. Insert the water filter into the upper
and lower clips in the correct direction.
Make sure to check the vertical
direction of the water filter.
NOTE
If the filter is installed horizontally, water
may remain in the filter. Therefore, vertical
installation is recommended.
English 35
2021-05-27
3:16:02
Publicité
