Transportation, Storage And Disposal - Husqvarna ST 427 Manuel D'utilisation

Error code
P0650
P0123
P0122
P0120
P0118
P0117
P0108
P0107
P0106
P0113
P0112
P0132
P0131
P0130
P0562
P0561
P0563
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from
electrical devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel
at an applicable disposal location
• Safely attach the product during transportation to
prevent damage and accidents.
• Keep the product in a locked area to prevent
access for children or persons that are not
approved.
876 - 014 - 19.05.2021
Error indicator fault.
Electrically short circuit in the throttle position sensor. 7
Electrically short ground in the throttle position sen-
sor.
Error in throttle position sensor.
Electrically short circuit in the sensor for cylinder cov-
er temperature.
Short circuit to ground in sensor for cylinder tempera-
ture.
Electrically short circuit in the inlet pressure sensor.
Short circuit to ground in the inlet pressure sensor.
Error in inlet pressure sensor.
Electrically short circuit in intake temperature sensor.
Short circuit to ground in the intake temperature sen-
sor.
Electrically short circuit in the oxygen sensor.
Short circuit to ground in oxygen sensor.
Error in oxygen sensor.
Battery voltage<12V.
Battery charges low voltage after startup.
Battery voltage<16V.

Transportation, storage and disposal

Error names
• Keep the product in a dry and frost free area.
• Charge the battery during long-term storage.
Examine and clean the battery terminals before
long-term storage.
Disposal
• Obey the local recycling requirements and
applicable regulations.
• Discard all chemicals, such as engine oil or
antifreeze, at a service center or at an applicable
disposal location.
• When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
Error indicator continu-
ously flashes times
It is only possible to use
OBD to read the error
code.
5
2
9
3
Always on after power
on.
Always on after start.
Always on after power
on.
27