Candy CDIMQ 4D622PB/E Mode D'emploi page 108

l
The message "SETTINGS" will appear
on the display and the indicator lights of
the "SMART DOOR/EXPRESS" and
"TABS" buttons will be on.
l
Pressing the "PROGRAMME SELECTION"
button until the "MEMO FUNCTION"
parameter is selected.
l
Parameter adjustment is performed by
pressing the "SMART DOOR/EXPRESS"
and "TABS" buttons to change the value
from "MEMO MODE ON" to "MEMO
MODE OFF" and vice versa.
l
Switch off the dishwasher by pressing the
"ON/OFF" button for 3 secs to confirm
the new setting.
To turn the alarm on again, follow the same
procedure.
Enabling or disabling DEMO MODE
(be used exclusively in stores)
Enabling
The dishwasher must ALWAYS be off
before you start this procedure.
1. Open the door.
2. Turn on the
ON/OFF button.
3. Press the "PROGRAMME SELECTION"
and "DELAY START" buttons together
for 5 seconds.
4. "DEMO MODE ON" will appear on the
display.
5. If no button is pressed for 30 seconds,
the programme will start, simulating the
start of a wash programme.
The Progr./Options/Start Delay options
are enabled, and by pressing these
buttons you can simulate the product's
functioning without starting a wash.
appliance using
Disabling "Demo mode"
WARNING
Once installed, if the appliance works
correctly but the wash cycle does not
start upon pressing the Start button,
"Demo mode" may not have been
disabled.
The dishwasher must ALWAYS be off
before you start this procedure.
1. Open the door.
2. Turn on the appliance using the On/Off
button.
3. Press the "PROGRAMME SELECTION"
and "DELAY START" buttons together
for 5 seconds.
4. "DEMO MODE OFF" will appear on the
display.
5. Switch off the appliance.
the
108