Publicité
Les langues disponibles
Les langues disponibles
NOTE
Cooling
• If there is a demand for cooling, unit will start
approximately 1 minute after mode is selected.
Heating
• If there is a demand for heating, unit will start
approximately 3 to 5 minutes after the mode is
selected.
• After the heating operation has stopped, Fan may
continue to run for approx. 30 seconds.
• When the room temperature reaches the set
temperature and the outdoor unit stops, the indoor
unit fan runs at ultra low speed and the outdoor
unit fan runs at low speed. (For high static ducted
type, the fan speed does not change after the
temperature has reached to the set point.)
During defrost operation, the fan stops so that cool
air is not discharged. ("
" Pre-heat is displayed.)
When restarting the operation after stop
• When attempting to restart the unit immediately after
it was stopped, the unit cannot start for approx.
3 minutes this is to protect the compressor.
13-EN
1117907101 EN FR.indb 7
1117907101 EN FR.indb 7
– 7 –
5
Timer operation
• Three timer modes are available: (Setting of up to 168 hours is enabled.)
OFF timer
: The unit stops when the set time is reached.
Repeat OFF timer
: The unit stops daily when the set time is reached.
ON timer
: The unit starts when the set time is reached.
Timer operation
■
1
3
Set
1
Push
button.
The Timer mode changes each time the button is
pushed.
OFF
OFF
ON
(
O
F
F
i t
m
e
) r
(Repeat OFF timer)
(
O
N
i t
No display
and timer display flashes.
•
2
Push
to select "set time".
• With every push of
button, the set time
increases by 0.5 hr (30 minutes).
When setting a time more than 24 hours for
timer operation, timer can be set in increments
of 1 hr.
The maximum set time is 168hr (7 days).
The remote control displays the set time with
time (between 0.5 and 23.5 hours) (
*1
number of days and time (24 hours or more) (
as shown below.
• With every push of
button, the set time
decreases by 0.5 hr (30 minutes) (0.5 - 23.5
hours) or 1 hr (24 - 168 hours).
Example of remote control display
• In the case of 23.5 hours (
)
*1
2
4
• In the case of 34 hours (
)
*2
Number of days Time
shows 1 day (24 hours).
shows 10 hours. (Total 34 hours)
m
e
) r
3
Push
button.
display disappears and timer time display
•
goes on, and
or
display flashes.
(When ON timer is activated, timer time, ON
timer
are displayed and other displays
disappear.)
4
Cancel of timer operation
Push
button.
Timer display disappears.
NOTE
) or
• When the operation stops after the timer reached
)
*2
the preset time, the Repeat OFF timer resumes the
operation by pushing
button and stops the
operation after the time of the timer has reached
the set time.
• When
is pushed while the OFF timer function
of the air conditioner is active, the indication of the
timer function disappears and then appears again
after about 5 seconds.
This is due to normal processing of the remote
control.
14-EN
3/21/16 11:44 AM
3/21/16 11:44 AM
Publicité
