Toshiba Carrier MMY-MAP0726HT6P-UL Manuel Du Propriétaire page 14

9
Power saving mode
Push button during operation.
• The air conditioner enters power saving mode.
appears on the display.
•
Power saving mode will stay in effect until it is
cancelled.
To cancel the power saving mode, push
button again.
disappears.
•
10
Performance
To save energy and perform comfortable cooling
and heating
Clean the air filter often
• A clogged air fi lter lowers the cooling/heating
performance.
Check
periodically!
Close windows and doors
• Do not let cooled/heated air escape from the room.
Close.
Do not cool/heat too much
WARNING
Do not expose your body to cool air directly for a
long time and do not cool yourself excessively.
Doing so may result in deteriorated physical condition
and ill health.
25-EN
1117907101 EN FR.indb 13 1117907101 EN FR.indb 13
NOTE
• Power saving mode consumes less energy, but
may not heat/cool the room as much as normal
mode.
• Even when operation start/stop, operation mode
change, or power reset is performed during the
power saving mode, the power saving mode is
retained until the next operation.
• Cooling/Heating too much is bad for your health.
In particular, take care with handicapped/old people
and children.
Do not cool
down too
much!
Cool/Heat the room evenly
• Adjust the air direction with the louver.
Exposing yourself to blowing air directly for a long
time is bad for your health.
– 13 –
Air conditioner operating conditions
For proper performance, operate the air conditioner under the following temperature conditions:
Outdoor temperature
Room temperature
Cooling operation
Room relative humidity: less than 80 %. If the air conditioner operates in excess of
[CAUTION]
this figure, the surface of the air conditioner may cause dewing.
Outdoor temperature
Heating operation
Room temperature
If air conditioner is used outside of the above conditions, safety protection may operate.
*1 : Low ambient cooling (23°F (5°C) or less) is limited to application.
*2 : The outdoor heat exchanger might be damaged by the frost, in case it is installed where the ambient
temperature falls below 5°F for more than 72 hours in running.
: 14°F *1 to 122°F (-10°C to 50°C) Dry bulb temperature
: 70°F to 90°F (21°C to 32°C) Dry bulb temperature
: 59°F to 75°F (15°C to 24°C) Wet bulb temperature
: -4°F *2 to 60°F (-25°C to 15.5°C) Wet bulb temperature
: 59°F to 82°F (15°C to 28°C) Dry bulb temperature
26-EN
3/21/16 11:44 AM 3/21/16 11:44 AM