Autosen AD006 Notice D'utilisation page 22

6 Electrical connection
The unit must be connected by a qualified electrician�
The national and international regulations for the installation of electrical
equipment must be adhered to�
Voltage supply to SELV, PELV
► Disconnect power�
► Connect the unit�
6.1 IO-Link connection
The IO-Link port must be connected according to the IO-Link specification� The
current required by the units depends on the current load of the sensor supplies�
6.2 Input configuration
The unit has digital type 2 inputs� Connected units must be suitable for these
inputs�
Maximum cable length: 30 m
7 Pin configuration
M12 connector IO-Link (X1)
1: + 24 V DC (US)
2: not connected
3: GND (US)
4: IO-Link
Inputs
1: + 24 V DC (US)
2: input DI2
3: GND (US)
4: input DI1
5: not connected
22