Autosen AO702 Notice D'utilisation page 14

6 Settings
During setting in the application, the sensor automatically selects the colour from
the 3 transmitter colours (RGB) with which there is the greatest contrast�
6.1 The sensor is to switch when the print mark is detected
1 ► Position the light spot on the contrast surface�
► Press [OUT on] for 2 s�
> LED flashes�
► Release [OUT on]�
2
> LED goes out� Measurement of the signal of the print mark
with the transmitter colours (RGB)�
> After 1 s the LED flashes 2 x�
3 ► Position the light spot on the background�
► Press [OUT off] and release it�
> LED goes out� Measurement of the background signal with
4
the transmitter colours (RGB)�
After 1 s the setting is completed�
6.2 The sensor is not to switch when the print mark is detected
► Position the light spot on the mark (see figure 1) and press [OUT off] for 2 s�
► Position the light spot on the background (see figure 3) and press [OUT on]�
Both settings can also be carried out first with the background (step 3) and then
with the mark (step 1)�
14