Abus TVVR60011 Manuel Utilisateur page 98

Settings
PPPOE
1. Tick the PPPOE box, enter the user name (Internet
access ID) and password, then confirm the pass-
word.
2. Confirm the settings by pressing Apply.
Warning
Use PPPOE only if there is no router available.
DDNS
1. To use the ABUS DDNS function, you must first set
up an account under www.abus-server.com. Please
note the FAQs on the website when doing this.
Tick the "Enable DDNS" box, enter 'ABUS DDNS' as
2.
the "DDNS Type", then enter www.abus-server.com
or "62.153.88.107" under "Server Address".
3. Confirm the settings by pressing Apply. The IP ad-
dress of your Internet connection is now updated on
the server every minute.
NTP
Note
The recorder can synchronise the time with an ex-
ternal server. Several server addresses are avail-
able on the Internet for this purpose.
Tick the "Enable NTP" box and then enter the inter-
1.
val at which the synchronisation should be made
again. Enter the IP address of the NTP server and
the NTP port.
2. Confirm the settings by pressing Apply.
Email
In the event of an alarm, the device can send a message
by e-mail. Enter the e-mail configuration here:
Parameter Setting
Enable Server Tick the box when authentication is
Authentica... made on the server of the Internet
provider
User Name E-mail account at the provider
Password Password connected to the e-mail
account
SMTP Server SMTP server address of the provider
SMTP Port Enter the SMTP port here
(Default: 25)
Enable SSL Tick the box to activate the e-mail
encryption
Sender Name of the sender
98