Abus TVVR60011 Manuel Utilisateur page 97

Settings
TAB General
Parameter Setting
Working Mode Net fault tolerance: Both network
adapters (NIC) use the same network
settings. The 2nd network adapter re-
mains, in the event of problems with
the 1st network adapter, available.
Load balance: Both network adapters
(NIC) use the same network settings.
The bandwidth is split between the two
adapters.
Multi-address (standard): The network
adapters (NIC) use different network
settings. One adapter is defined as the
standard adapter for external commu-
nication. The 2nd adapter is used for
connecting IP cameras.
Select NIC Choose between LAN1 and LAN2 for
editing.
NIC Typ Set the transmission speed of the in-
stalled network card here.
Tip: 10M/100/1000M self adaptive
Enable DHCP Tick the box if the IP addresses are
assigned dynamically via DHCP in the
network.
DHCP activated: Subsequent entry
fields are inactive (parameters as-
signed via DHCP).
Note:
If the IP addresses are assigned man-
ually, ensure that DHCP is not active
(box not ticked).
IPv4 Adress Address of the network device in the
network (manual assignment)
IPv4 Usually 255.255.255.0
Subnet Mask
IPv4 Default Address of the gateway for Internet ac-
Gateway cess
IPv6 Adress 1 Currently no functioning
IPv6 Adress 2 Currently no functioning
IPv6 Standard Currently no functioning
Gateway
MAC Adress Hardware address of the installed net-
work card
MTU (Bytes) Describes the max. size of the largest
protocol data .
Preferred Address of the Domain Name Server
DNS Server (usually the IP address of the gateway)
Alternate DNS IP address of the alternative DNS
server
Default Route Selection of the Ethernet connection
for the external network connection
97
(e.g. Internet).
Note
In certain modes some of these settings cannot be
selected.