Onkyo CR-265 Manuel D'instructions page 28

Setting the Clock
This manual describes the procedure for using the
remote controller, unless otherwise specified.
1 Press the [TIMER] button repeatedly to
display "Clock."
If the clock has not been set yet, only "Clock"
will appear.
2 Press the [ENTER] button.
3 Press the [q]/[w] buttons to set the day of
the week, then press the [ENTER] button.
Mon Tue Wed
4 Press the [q]/[w] buttons to set the hour,
then press the [ENTER] button.
To switch between 24-hour and 12-hour display,
press the [DISPLAY] button.
5 Press the [q]/[w] buttons to set the minute,
then press the [ENTER] button.
When you press the [ENTER] button, clock count
starts from 00 seconds.
Displaying the clock time
If the CD receiver is in standby mode, press the
[CLOCK CALL] button. The clock time appears on the
display for about 8 seconds. While the CD receiver is
turned on, press the [CLOCK CALL] button. The clock
time is displayed continuously.
Note:
• If a power outage occurs, the clock will stop and
"-- : --" will appear. Also, all programmed timers will
be canceled. Set the clock again, and turn on the
necessary timers.
28
En-
Thu Fri Sat Sun
Using the Timer
This manual describes the procedure for using the
remote controller, unless otherwise specified.
The CD receiver features a sleep timer that places the
unit into power standby mode after a specified period of
time. It also features four programmable timers that
initiate playback of a specified source at a specified
volume level at a specified time.
Using the Sleep Timer
When the sleep timer is enabled, the CD receiver will
enter power standby mode after a specified period of
time.
1 While the power to the CD receiver is on,
press the [SLEEP] button.
"Sleep 90" appears for about 8 seconds, then the
unit will enter power standby mode in 90 minutes.
While the sleep timer is enabled, the SLEEP
indicator appears on the display.
2 While the Sleep time is displayed, press
the [SLEEP] button repeatedly to set the
desired time.
Each press of the [SLEEP] button will shorten the
sleep time in 10 minute increments.
Checking the Remaining Sleep Time
To check the remaining sleep time, press the [SLEEP]
button. You can shorten the sleep time in 10 minute
increments by pressing the [SLEEP] button while the
sleep time is displayed.
Canceling the Sleep Timer
To cancel the sleep timer, press the [SLEEP] button
repeatedly until "Sleep Off" appears. If you want to
power off the CD receiver immediately, press the [8]
button.
Programming a Timer
Before programming a timer, you must set the clock.
(see page 28) Also, if you plan to program a timer for
FM or AM, first you must preset the desired FM or AM
broadcast stations (see page 25).
1 Press the [TIMER] button repeatedly to
select a timer number (1–4).
If only "Clock" appears, the clock has not been
set yet. Set the clock first (see page 28).
2 Use the [q]/[w] buttons to select "On",
then press the [ENTER] button.