Publicité
7
7
If the vehicle was not equipped with factory splash
guards, then proceed to Step 8. If the vehicle was
equipped with factory splash guards, re-install the (2)
two previously removed factory Phillips head screws
with the ratchet, appropriate socket and supplied Phillips
bit through the holes in the MudFlap to a snug fit. Then,
re-install the (1) one previously removed factory plastic
fastener through the hole at the underside of the fender.
9
9
If the vehicle was not equipped with factory splash
guards, then proceed to Step 10. If the vehicle was
equipped with factory splash guards, press the MudFlap
up to the fender and use the ratchet, appropriate socket
and supplied Phillips bit to fully tighten the (2) two factory
Phillips head screws.
11
11 11 11
Congratulations! Your new WeatherTech® No-Drill
MudFlaps have been installed! Lifetime Limited Warranty
against defects in materials and workmanship when
installed correctly.
WARNING:
The MudFlap is designed to fit vehicles with standard sized wheels and tires. Installation of MudFlaps on vehicles with aftermarket
wheels or oversized tires may interfere with the MudFlap, will void the warranty and may damage the MudFlap or the vehicle.
(630) 769-1500
weathertech.com/warranty
View: Underside of fender
8
8
Take (2) two supplied U-Clips and install in the slots of the
MudFlap at the inner fender. Place them so they clamp
around the MudFlap and backside of the fender. Then, use a
flat screwdriver to push each onto the MudFlap and fender.
*Note: There will be two holes in the MudFlap not used for vehicles without
factory splash guards originally installed.
10
10
Install the passenger side MudFlap marked "RH,"
repeating Steps 3-9.
Publicité
