Electrical Connection; Electrical Requirements - Bosch HDIP056U Instructions D'installation

en-us Electrical connection
Flip levers on hinges toward you.
2.
If necessary, use a tool, such as a screwdriver, to gently
pry the upper part of the lever away from the housing.
Take care to avoid scratching the housing.
Bring both door hinge levers to their fullest down posi-
3.
tion. The left and right door hinges differ slightly but op-
erate in the same manner.
4.
CAUTION - Risk of injury! Follow the instructions
below to prevent the latch from slamming shut and
pinching or cutting your hand.
Close the oven door until it catches on the hinge stop
levers, locking the hinges at the proper angle for door
removal.
a The door will be open about 7" (18 cm) at the top.
6.1 Electrical requirements
Make sure your electrical installation supports the follow-
ing requirements.
Gas models
120 V, 15 A minimum, 60 Hz is required. The 120 V power
cord is factory-installed.
Dual fuel models
This appliance must be supplied with the proper voltage
and frequency and connected to an individual, properly
grounded branch circuit, protected by a circuit breaker or
fuse having amperage as specified on the rating plate.
See information on rating plate. → Page 19
10
5.
CAUTION - Risk of injury! The door is heavy.
Do not grip the door by the handle.
▶
Use both hands to firmly grip it by the sides.
▶
Maintaining the door angle, lift the door straight up ap-
proximately 3/4" (2 cm) to unhook the hinges from the
slots and then pull it out towards you until the hinges
are clear of the oven housing.
Place the door in a convenient and stable location.
6.
Do not lay the door on its handle. This could cause
dents or scratches.
6 Electrical connection

Electrical connection

Read these instructions to safely connect your appliance
Electrical connection
to the electrical supply.
WARNING
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician install an outlet near
the appliance.
This product must be properly grounded.
Check with your local utilities for electrical codes which ap-
ply in your area. Failure to wire your appliance according
to governing codes could result in a hazardous condition.
If there are no local codes, your range must be wired and
fused to meet the requirements of the National Electrical
Code, ANSI/NFPA No. 70–Latest Edition.
The range requires a minimum of a three-wire 120/240 V
or 120/208 V, 25 or 30 A, 60 Hz AC circuit. Check local
codes for proper amperage ratings. A four-wire connection
is preferred. Most local building regulations and codes re-
quire that electrical wiring be done by licensed electri-
cians. Be sure to install your range according to the elec-
tric codes in your region.