Honeywell Home TH6320ZW2007 Guide D'utilisation page 10

Z-Wave temperature and humidity reporting
This thermostat may be configured to report the actual room temperature in
a higher resolution than can be shown on the thermostat display. The default
temperature reporting resolution will be 1 °F or 1 °C. To change default temperature
reporting to a higher resolution, go to thermostat MENU/Z-WAVE SETUP/TEMP
REPORT. The temperature is reported by every displayed value change, and no later
than 2 hours from last report. The thermostat can be configured to report changes
in temperature less frequently. This is recommended to increase battery life when
the thermostat does not use a common wire (C wire). Available setting range is
0.5 °- 5 °F (0.5 ° - 3 °C).
NOTE: When higher temperature resolution reporting is set, you may experience
different resolution of temperature displayed on the thermostat and Z-Wave
controller.
Humidity Reporting
The thermostat can be configured to report changes in humidity less frequently.
This is recommended to increase battery life when the thermostat does not use a
common wire (C wire). Available setting range is 1% RH 5% RH (default 1% RH). To
access this setting, go to thermostat MENU/Z WAVE SETUP/HUM REPORT.
Z-Wave connection status
Z-Wave connection status is located in the upper-right corner
of the screen.
• Thermostat is included and connected to a Z-Wave
network.
Wifi is on and
connected
Wifi is on and
• Flashing Icon. (TH6320ZW2007 model only.) Thermostat
connected
is in the INCLUDE MODE using SmartStart. This occurs
Wifi is on and
connected after initial setup and time and date are set. Include mode
or wifi is not setup
shown on page 9.
or wifi is not setup
Wifi is off
• Thermostat is excluded from a Z-Wave network.
or wifi is not setup
Wifi is on and
connected
Wifi is off
• Thermostat is either included in a Z-Wave network but the Z-Wave signal
Wifi is off
is lost, or is included but AC power is lost (battery used as backup). In this
case, Z-Wave radio is turned off to preserve battery life. AC power must be
or wifi is not setup
restored or you have to change the power mode. It can be done via excluding
thermostat from Z-Wave network and including again in battery power mode
Wifi is off
where batteries are used as main power source. You can check the actual
power mode in the thermostat MENU/DEVICE INFO.
Finding DSK and DSK Pin Code
The 5-digit DSK Pin Code can be found on the label on the back of the thermostat
and by selecting MENU then arrow right to "Z-WAVE SETUP", then right arrow to
"GET DSK CODE" and touching select. Full DSK can be found on the box of the ther-
mostat.
10
AM
Following Schedule
Mode Fan
Heat Auto
Away Home Sleep
Mode Menu Fan
Example of thermostat
included and connected in a
Z-Wave network.