DK2 POWER OPC513 Manuel De L'utilisateur page 24

hands Ensure you do not allow your hands inside the feed chutes.
NOTE: To clear the top-loading chute, turn the key off, remove it, unplug the spark plug. Be safe,
the cutters on this machine are high-speed and very sharp.


CAUTION! Set both of your wheel brake pins to stabilize the machine during operation.
TREE CHIPPING
1. Always chip wood on the highest engine speed.
2. Feed smaller trees into the side feed chute and let go, the tree will be pulled in by the force of
the blades and cutter wheel.
3. Feed larger trees slowly to allow the cutter wheel to regain speed between cuts
4. Feed leaves, twigs, and branches up to 3/8 inches in diameter into the top-loading feed chute.
24 | OPC513 man.