Télécharger Imprimer la page

DK2 POWER OPC513 Manuel De L'utilisateur page 13

Publicité

Les langues disponibles

Les langues disponibles


WARNING! OPERATION
• Never place your hands, feet, or any part of your body in the chipper chute, discharge
opening, or near or under any moving part while the engine is running. Keep clear of
the discharge opening at all times. If it becomes necessary to push material into the
chipper chute, use a small diameter stick, NOT YOUR HANDS.
• Keep your face and body back from the chipper chute to avoid accidental bounce back
of any material.
• If the cutting mechanism strikes a foreign object or if your machine should start making
an unusual noise or vibration, immediately stop the engine. After the machine has come
to a complete stop proceed as follows:
• Remove the spark plug wire(s) and wait for all moving parts to come to a complete
stop.
• Inspect for any damage.
• Repair or replace any damaged parts before restarting and operating the machine.
• Exercise caution to avoid slipping or falling.
• If the machine should start to vibrate abnormally, immediately stop the engine, and wait
for all moving parts to come to a complete stop and inspect for the cause. Vibration is
generally a warning sign of trouble.
• Stop the engine when leaving the operating position, and when making any repairs,
adjustments and inspections. STAY CLEAR OF THE CHIP CHUTE AT ALL TIMES.
• Take all possible precautions as recommended by the manufacturer when leaving the
machine unattended.
• Before cleaning, repairing, or inspecting, shut off the engine and make certain the
flywheel and all moving parts have come to a complete stop. Disconnect the spark
plug wire(s) and keep the wire away from the spark plug to prevent accidental starting.
• Keep all guards and safety devices in place and operating properly. Do not operate the
machine if all safety guards are not in place.
• Do not use the unit with the chipper hopper removed.
• Do not overload or attempt to chip material beyond 6 inches.
• Only use accessories approved for this machine by the manufacturer. Read, understand,
and follow all instructions provided with the approved accessory.
• Only operate the equipment in good daylight. Do not operate this equipment at night
or in dark areas where your vision may be impaired.
• Use extreme caution when reversing or pulling the machine towards you. NEVER move
the machine while it is running.
• Do not tamper with the engine's governor setting. The governor controls the maximum
safe operation speed and protects the engine. Over-speeding the engine is dangerous
and will cause damage to the engine and to the other moving parts of the machine.
• Start the engine according to the manufacturer's instructions. Keep hands and feet
away from the inlet and discharge areas.
• Do not operate while under the use of alcohol, drugs, or medication. A clear mind is
essential for safety.
• When feeding material into this equipment, be extremely careful that pieces of metal,
rocks, or other foreign objects are not included. Personal injury or damage to the
equipment could result.
• Do not allow an accumulation of processed material to build up in the discharge area
as this will prevent proper discharge and can result in kick-back from the chipper chute.
v.230223 | 13

Publicité

loading