Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Feed UAS connectors into
forward-facing belt path. The
UAS connectors are easier to
feed through by routing behind
cover.
5. Place car seat forward-facing
in back seat of the vehicle.
Centre the car seat between
the vehicle UAS anchors. The
entire seat bottom should sit
flat on the vehicle seat.
6. Loosely attach tether strap.
Do not tighten. Consult
vehicle's owner manual for
specific location.
7.
Attach UAS connectors to
vehicle's UAS anchors and
listen for audible click to
confirm engagement. UAS
strap should lie flat and not be
twisted.
42
1-866-954-9786
8. Tighten the UAS strap. Press
7 4
9. Test for tightness. Grab the
5 5
10. Tighten the top tether strap.
6 6
8
7
down firmly in the centre of
the car seat while tightening
the UAS strap. You may need
to tighten through the opening
in the pad at the belt path as
shown, by
own, by pulling it through
pulling it through
and up.
and up.
side of the seat with one hand
where the UAS strap is and
slide the car seat side-to-side
and front-to-back. If the seat
moves less than 2.5 cm (1 in),
it is tight enough. Do not test
by grasping top or front of the
seat.
Push the car seat back while
tightening the tether strap to
remove all the slack.
diono.com
9
8
10
9
11 10
43
Publicité
Chapitres
Table des Matières
