Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Place car seat rear-facing
in back seat of the vehicle.
Centre the car seat between
the vehicle UAS anchors. The
entire seat bottom should sit
flat on the vehicle seat.
6. Thread the UAS strap through
the rear-facing belt path and
out the other side. The UAS
strap should lie flat and not be
twisted.
7.
Attach UAS connectors to
vehicle UAS anchors and
listen for audible click to
confirm engagement.
32
1-866-954-9786
8. Tighten the UAS strap. Press
5
9. Test for tightness. Grab the
6
10. To remove UAS strap from
7
down firmly in the centre of
the car seat while tightening
the UAS strap. You may need
to tighten further by pulling
upwards in-line with the belt
path as shown.
side of the seat with one hand
where the UAS strap is and
slide the car seat side-to-side
and front-to-back. If the seat
moves less than 2.5 cm (1 in),
it is tight enough. Do not test
by grasping top or back of the
seat.
vehicle, use UAS release on the
UAS connectors and pull them
off the anchor bars.
diono.com
8
9
10
33
Publicité
Chapitres
Table des Matières
