Télécharger Imprimer la page

Thermor Equateur 2 Notice D'installation Et D'utilisation page 91

Publicité

Les langues disponibles

Les langues disponibles

GB
If your installing includes a consumption reducer, this can alternatively cut the heating
radiators (depending on your contract with your energy supplier).
Caution, A load shedding system by a power supply cut is incompatible with our radiators
because it damages the thermostat. During load shedding periods, your radiator will
display « Load shedding ». It then returns to its initial operating mode.
During consumption reduction periods, your radiator will display "Consumption reduction".
It then goes back to its initial operating mode.
Do not perform any maintenance action before switching your equipment off by doing a
long press on the
If you want to maintain the performances of your radiator, you will need to use a vacuum
cleaner or a brush to remove dust from the lower and upper radiator grills about twice
every year.
You can clean the radiator with a damp cloth; never use abrasive products or solvents.
Dirt can accumulate on the radiator grill in a polluted environment. This phenomenon is
related to the poor quality of ambient air. It is recommended that correct aeration of the
room (ventilation, air intake, etc.), and cleanliness of the air should be verified if this arises.
Such dirt will invalidate the radiator replacement guarantee.
Problem encountered
The radiator does not
heat
The radiator heats all
the time
User's manual
13 - IF YOU HAVE A LOAD SHEDDING
14 - MAINTENANCE
button.
15 - IF A PROBLEM OCCURS
If you are in programming, make sure that the program is in
COMFORT mode.
Make sure that the circuit breakers of the installation are
closed or that the load shedder (if you have one) has not
switched the heating off (see part 13 "If you have a load
shedding).
Check the air temperature in the room; if it is higher than
the set temperature, the heating pictogram will not come on
and the radiator will not heat.
Check that the radiator is not located in a draft, and that the
temperature setting has not been modified.
Check to be made
89

Publicité

loading