Thermor Equateur 2 Notice D'installation Et D'utilisation page 56

GB
In this case, make the following checks to verify that programming orders are transmitted
correctly:
Signal to be
transmitted
Frost free and load shedding orders take priority when programming is done through pilot
wire or power line.
The time to changeover from Comfort mode to Eco mode is of the order of 12 seconds.
1.5 - Lock the radiator on its wall-mounting frame
- Place the radiator on wall-mounting frame S as
shown on the diagram.
- Bring the radiator to the wall-mounting frame and
then lift it (arrows 1 and 2).
- Insert the wall-mounting frame tabs in the radiator
holes and then lower the radiator (arrow 3).
- Lock by turning the 2 V screws by half a turn and
your radiator is fixed.

54
Orders No
Received current
Mode
COMFORT
Obtained
User's manual
230V for 3s 230V for 7s
COMFORT COMFORT
-1°C -2°C
-115V
230V
négative
FROST
ECO
FREE
+115V
positive
SWITCH
HEATING
OF /
LOAD
SHEDDING