Albrecht Audio DR 315 C Guide D'utilisateur page 73

14.3 Settings
14.3.1 Scan setting
By default, FM scans stop at any available station.
This may result in a poor signal-to-noise ratio (hiss)
from weak stations. To change the scan settings to
stop only at stations with good signal strength, select
[Menu] > Scan setting > Strong stations only? > Yes.
14.3.2 Audio setting
By default, all stereo stations are reproduced in stereo.
For weak stations, this may result in a poor
signal-to-noise ratio (hiss). To play weak stations in
mono, select [Menu] > Audio setting > FM weak
reception: Listen in mono only? > Yes.
15 Aux in mode
Aux in mode plays audio from an external source such as an MP3 player.
To play audio with Aux in mode
1. Turn the volume low on both DR 315 C, if adjustable
the audio source device.
2. Connect the external audio source to the Aux In
3.5 mm stereo socket.
3. Either press MODE until the display shows AUX in
or select [Menu] > Main menu > AUX in.
4. Adjust the volume of DR 315 C (and if necessary the
audio source device) as required.
English 73