Hama FC10 Metal Mode D'emploi page 5

Note
• To be able to charge your device via the wireless charger, it must be compatible with induction charging
technology. For more information, please refer to the operating instructions of your device.
• Note that mobile phone cases, covers, etc., and other materials between the wireless charger and the
back of your device may interfere with or even prevent the charging process.
• Connect the enclosed USB-C cable with the USB-C input (1) on the inductive charger and the USB output
on the enclosed quick-charging device.
Note
• The maximum charging power of up to 10 W is guaranteed with the enclosed Qualcomm quick-charging
device.
• An active power supply is con rmed by the status LED (2) lighting up red.
Warning
Do not use defective chargers or USB ports and do not attempt to repair them.
• Place your device with its back on the inductive charger (B).
• The charging process begins as soon as an effective induction eld has been established. The status LED
(2) lights up solid blue. The current charge status is displayed on your device.
• If no induction connection can be established, change the position of your device if necessary (B).
• The charging process ends automatically once your device's battery is fully charged. The status LED (2)
goes out.
5. Care and maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents. Ensure
that no water is able to enter the product.
Note
Disconnect the device from the mains before cleaning and during prolonged periods of non-use.
6. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper
installation/mounting, improper use of the product or from failure to observe the operating instructions and/
or safety notes.
4