Publicité
Les langues disponibles
Les langues disponibles
4
3. Remove any remaining line.
4. Clean dirt and debris from all parts. Replace spool (3) if it
is worn or damaged.
5. Align the spool tabs with the tab openings in the base of
the spool (4).
6. Push the spool cover until it clicks into position.
10.4
INSTALL THE CUTTING LINE
Do not put more than 15 feet of cutting line in at a time.
1. Remove the remaining cutting line on the spool.
2. Line up the slots (1) on the spool cap with the slots (2) on
the trimmer head.
Spool Cap
Trimmer Head
Trimmer Head Hole
1
2
3
NOTE
Slots
Slots
English
3. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap clock-wise to wind the cutting line
into the trimmer head. Keep approximately 5 in of cutting
line above out of each side of the trimmer head.
5.1"
(130
)
mm
=
10.5
REMOVE THE TRIMMER HEAD
1. Put the metal rod (1) in the specified angle transmission
hole to fix the trimmer head.
11
1
2
5.1"
(130
)
mm
=
EN
Publicité
