Locating The Drive On Your Desk; Connecting To Your Computer - Verbatim PHP3 Guide De L'utilisateur

Locating the Drive on Your Desk

Place the drive on a sturdy desk or table that is free from clutter that could block airflow
around the unit. The drive is designed to lie flat on its rubber feet, or may stand upright. In
either orientation take care not to block any air vents.

Connecting To Your Computer

This Verbatim external hard drive provides both FireWire and USB 2.0 connections. You
can connect your drive to a computer with either FireWire or USB, but not both at the
same time.
Connecting your drive to a computer is extremely simple. Follow the steps below.
1. Connect the included AC Adapter to the drive, and then to a wall outlet.
2. Next press the ON/OFF button on the back of the drive.
3. Finally, connect the data cable. Connect the included USB cable from the USB port on
the drive to an available USB port on your computer. For FireWire, connect the included
FireWire cable from one of the FireWire ports on the drive to an available FireWire port
on your computer.
4. The hard drive will mount automatically, and a new icon will appear in My Computer
(Windows) or a new icon will appear on the desktop (Mac).
Depending on your computer's operating system and the interface type you are using, the
following special notes may apply:
Note 1: USB under Windows. If you are using a USB 1.1 port on your Windows computer,
the following cautionary note may appear on your display: Hi-Speed USB Device plugged
into non-Hi-Speed USB hub. This does not indicate a problem because the drive is compat-
ible with both USB 1.1 and USB 2.0 ports. Simply close the message and proceed. However,
4