Publicité
Les langues disponibles
Les langues disponibles
b. Disconnect from mains supply; then connect again
c. Start the programming mode by pressing the programming
button on the WeiTronic remote control unit briefly
d. Pairing the receiver unit: Press the UP button briefly within
one second of the heating system turning on at 100 %
output. Then press the DOWN button briefly within one
second of the heating system turning on at 50 % output.
The receiver quits the programming each time after briefly
being turned off.
To pair other remote control units, see programming instructions
in the appendix.
Programming the output levels
The factory default settings for the Combio-868 LD brightness
levels are at 100 % and about 50 % and can be called up with a
quick double click on the UP or the DOWN button. The stored
levels can be re-programmed easily.
1. Switch the remote control unit to the channel for heating.
2. Use the dimmer to go to maximum or minimum.
3. Press the UP or DOWN button until the desired output level
has been reached.
Important:
Keep the UP or DOWN button pressed until the desired output
level has been reached!
4. As soon as the desired output level has been reached, also
press the STOP button. The dimming process stops and the
new level is stored.
44
Publicité
