Publicité
Les langues disponibles
Les langues disponibles
WeiTronic Combio-868 HD 1.5 kW
Installation and Operating Instructions
Remote control heater adjustment
The Combio-868 HD can be used to turn the Tempura heating
system on and off and to set the level.
Intended use
The Combio-868 HD may only be used for controlling Tempura
heating system.
The Combio-868 HD 1.5 kW is suitable for a Tempura with a
nominal output of 1500 watts.
Note:
Do not shorten or lengthen aerial.
1. Install the Tempura or Tempura Duo as described in the
assembly instructions accompanying the heating system.
2. Disconnect from the mains.
3. Connect the Combio-868 HD 1.5 kW to the heating system.
A STAS 3 Hirschmann plug is connected to the heating system,
which can be connected directly to the output of the receiver
unit. Do not remove this plug and especially not the silicon
cable attached to the Tempura!
The Hirschmann plug on the Tempura is wired as follows:
41
Publicité
