Philips Sonicare ProtectiveClean 4700 Serie Mode D'emploi page 19

Charging and battery status
Charging
Charging with the travel case
This Philips Sonicare toothbrush is designed to provide at
least 28 brushing sessions, each session lasting 2 minutes
(14 days if used twice per day) on a fully charged battery.
The battery indicator shows the battery status when you
complete the 2-minute brushing session, when you pause
the toothbrush, or while it is charging.
Note: It can take up to 24 hours to fully charge the
battery before first use, but you can use the Philips
Sonicare toothbrush before it is fully charged.
Charging on charger or UV Sanitizer
1 Plug the charger or sanitizer into an electrical outlet.
2 Place the handle on the charger or sanitizer.
- The handle emits 2 short beeps to confirm that the
handle is placed properly.
- The flashing light of the battery indicator shows that
the toothbrush is charging.
- When the handle is fully charged on the charger, the
battery indicator lights up green for 30 seconds and
then switches off.
Note: Accessories included may vary based on the model
purchased.
1 Insert the USB cable to the charging travel case.
2 Connect the attached USB cable to the 5V DC input
power either from:
- The USB adapter provided.
- A UL-listed or certified to ANSI/UL 60950-1
personal computer's standard USB connector.
- A UL-listed or certified to ANSI/UL 60950-1 LPS
power supply with USB output port.
- A UL-listed or certified 1310 Class 2 power supply.
Important: The wall adapter must be a safe extra low
voltage source, compatible with the electrical ratings
marked on the bottom of the device.
3 Place the handle in the charging travel case.
19
English